Swiss machines work differently. Especially if you have been using lathes before, you can tell the difference. While the description of which works better between the two machines is rather subjective, you may be leaning towards Swiss machines when it comes to finishing loads of work.
Safety is a top concern
If you were to use a Swiss type of machine, you would be running workpieces on the machine safely. Do you need to make loads of heavy cuts? With a Swiss-type machine, you can make those heavy cuts – and you can make them safely. Alongside, deflection should be among the least of your worries.
If you were to use a lathe, you might need to make those heavy cuts many times. You may also need to keep the cutting forces at a low level. With a Swiss machine, all you need to do is cut once without any backtracking.
Twice the speed
Try focusing on chip-to-chip, or chipping on your work pieces from one tool to the next. Usually, the chip-to-chip process can take a while. However, if you were using a Swiss machine, you would not be saying the same.
On a Swiss, one second – or even just a fraction of it – is all you need.
The machines are very compact. Therefore, moving too far from each other is unnecessary for the tools.
If you compare Swiss machines to lathes, you will notice a difference in the products’ quality – especially if you need to make heavy cuts. Swiss machines can do the job a lot faster, too. While the roundness, as well as the straightness of the bar you choose, plays an important role, the machines tend to perform almost as well as your chosen bar.
You simply need to watch out for the bar you choose on the Swiss machines. If you go with something round, you get something round as a result. If you go with a bent bar, a bent result is yours.